Owner manual

Guilin Feiyu Electronic Technology Co., Ltd.
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyu-tech.com [e-mail]
Page 2
direction(Maximum 6m/s),not aircraft attitude.
 Auto Return To Launch Mode(RTH)
The GPS Module must be connected to the DOS with at least 5 GPS satellites detected. In this Mode,
DOS is take over all the control, the RC aileron, elevator, throttle and rudder stick is no control function
anymore. When you switch into RTH mode, DOS (DOS has 20m altitude protection limit, if the switch
point altitude below 20m, DOS will automatic climb to 50m) will first automatic adjust the aircraft heading to
the home point and automatically fly the aircraft back to the take-off point, while maintaining altitude. Upon
reaching the launch area, the unit will automatically landing and closed the engine.
 Camera Gimbal Stabilization
DOS multi-rotor firmware,when is used to control the aircraft under 6 axis, can simultaneously control two
axis Camera Gimbal Stabilization.
 DOS can connect with the Hornet-OSD and the Data Radio
DOS has one UART interface for connecting the FY-data radio and the OSD module. It can realize the
following function by combing them.
First Person View (FPV) : Can be connected to the Hornet - OSD, the flight data overlay to video
output,and through the vodeo transmission system to send back, let you enjoy the fun of FPV. And it will be
easier to operate FPV with the functions of automatic balance, Hovering and Auto Return To Launch.
Real time telemetry-real time monitor : Real time telemetry-real time monitor the flying state, using the
Data Radio to lengthen the remote control distance.
For more information, please refer to the FY-OSD and FY Data Radio manual.+
1. DOS standard configuration
Standard configuration
●DOS control module *1;
●RC receiver connecting wires * 1;
●USB cable *1;
●Velcro double sided tape * 2;
Optional accessory
●DOS vibration absorbing mount *1;
●GPS module *1;
●Hornet OSD module;
●Data Radio;
●Remote Adaptor;
2. Technical Specification
DOS module
Input voltage : 4.0 ~ 6.0 Volt;