Owner manual

Guilin Feiyu Electronic Technology Co., Ltd.
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyu-tech.com [e-mail]
Page 16
 Navigation control Gain
Navigation control Gain is the control parameters use for control hovering point.
Control P : please increase the basic gain slowly (2-3 each time)until the vibration emerges in the
hovering point. Then decrease the gain a little until vibration just disappears. Now the gain is perfect.
Control I : This value generally do not need to adjust.
 Camera Gimbal Stabilization adjust instructions
Attention: Please do not adjust the Camera Gimbal Stabilization untill you have finished the multi-rotor aircraft
adjust.
Please according to following steps to adjust Camera Gimbal Stabilization :
(1) Gimbal Reverse
1)Shaking the Camera Gimbal on roll direction , if DOS not give the corresponding reverse correction,
please choose Roll reverse.
2) Shaking the Camera Gimbal on pitch direction , if DOS not give the corresponding reverse correction,
please choose pitch reverse.
(2) Gimbal Gain
The default Gimbal Gain:Roll 50,Pitch 50.
Under the condition of servo no rotation, you should control the camera gimbal with RC stick. If the servo
shaking when the stick in the neutral position, that’s indicates the sensitivity is too big. As a result, you should
slowly decrease(10% -20% each time) corresponding direction Gimbal Gain, until the shaking situation
disappear.If the camera gimbal go back to Neutral is too soft, As a result, you should slowly increase(10%
-20% each time) corresponding direction Gimbal Gain
(3) Gimbal Neutral
The default Gimbal Neutral is 1520.
Power on and put the camera gimbal into level position,observe the servos position.If the servos is not in
the Neutral value,please through adjust the to corresponding servos Gimbal Neutral to make them into Neutral
value position.
Adjusting method: According to corresponding servo reaction, appropriate increase or decrease
corresponding servo Gimbal Neutral.
—— END ——
Note: We reserve the right to change this manual at any time! And the newest edition will be shown on our
website www.feiyu-tech.com.