User guide

Guilin Feiyu Electronic Technology Co., Ltd.
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn [e-mail]
Page 19
Via remote control and OSD overlay menu set FY-41AP
① Activate the OSD setup menu: switch "ABM" to the "3D mode" 6 times in SW1, between
two switching it has to be less than 3 seconds, the process is as follows: ABM → 3D mode
→ABM →3D mode → ABM → 3D mode → ABM → 3D mode →ABM → 3D mode →ABM→
3D mode. This will activate OSD setup menu interface.
② Move Elevator stick to the project you want to set.
③ Move aileron stick to the project you want to set.
④ Please put elevator stick to SAVE, after your setting.Through the stick of ailerons carried
out to save the action, when saving, "SAVE" will flicker for two seconds, the end of the
flashing, been saved successfully.
NO.
Setup instructions
NO.
Setup instructions
1
Auto-control rudder surface
reverse
10
circling radius setting
2
Control gain
11
Farthest flight distance setting
3
ailerons
12
RC mode (receiver / data
transmission radio)
4
Elevator
13
Rudder mixing mode
5
Rudder
14
Initialize gyroscope
6
Throttle
15
Record flight attitude
7
Three-switch mode selection
16
Save the settings