User guide

Guilin Feiyu Electronic Technology Co., Ltd.
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn [e-mail]
Page 4
Under the condition of servo no rotation, you should control the PTZ camera
gimbal with RC stick. If the servo shaking when the stick in the neutral position,
that’s indicates the sensitivity is too big. As a result, you should slowly adjust the
sensitivity knob to “middle” position, until the shaking situation disappear.
After the PTZ camera gimbal servo and the FY-30A control sensitivity are all
normal, you can record the neutral position. Do as following, power on the FY-30A,
when the RC stick is in the neutral position, switch Auto Stabilization mode to 3D
mode one time, it will record the neutral position successfully.
The purpose of recording the neutral position is to lock the target heading,
FY-30A can judge the RC stick is in the middle position or not according to the
neutral value. That is to say, when the rudder stick is in the neutral position, the
current direction will be recorded to lock the target heading. While the pitch and roll
stick is in the neutral position, it will lock the level position.
When let go of the operation of RC rudder and roll stick, it will switch to
neutral position automatically. At this time, FY-30A will lock the current heading
and level position, it will compensate with the movement of PTZ camera gimbal
fixed part, as a result, the PTZ camera gimbal will keep stable.
—— END ——
Note: We reserve the right to change this manual at any time! And the newest edition will be
shown on our website www.feiyudz.cn.