User guide

Guilin Feiyu Electronic Technology Co., Ltd.
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn [e-mail]
Page 3
You should set the DIP switch to the right position when control PTZ
camera gimbal .(The DIP switch position is shown as below.)
You will require a +5V battery to power on the RC receiver and FY-30A.
After power on, when the RC stick is in the neutral position, the PTZ camera
gimbal should keep the same attitude, that is to say, the servo will not roll. If the
servo continues rolling, you should power off and adjust the sensitivity knob to the
negative direction. (for example, if the rudder continues rolling, adjust the “RUD”
sensitivity knob, if the elevator continues rolling, adjust the “ELE” sensitivity knob.)
the sensitivity knob position is shown below.