User guide

Guilin Feiyu Electronic Technology Co., Ltd.
Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn service@feiyu-tech.com
Page 2
Connect one servo at each time, and testing them one by one. Be sure not to
connect multiple at one time.(shown as below)
If the servo continues rotation, the control servo stalling signal will be
inconformity with RC default output neutral position. You can adjust fine tuning of
the RC corresponding channel to compensation, until the servo stop rolling.
If all the servos are ok, start to install FY-30A control module, and connect the
servos and RC receiver to the FY-30A control module. In this example, the servos
connect to FY-30A ELE and RUD channel, and the RC receiver is connected to the
same position.shown as below