User guide

ManualsBrandsFeiYu Tech ManualsAccessories communicationFY-30A

Guilin Feiyu Electronic Technology Co., Ltd.

Guilin Feiyu Electronic Technology Co., Ltd http://www.feiyudz.cn service@feiyu-tech.com

Page 1

Operate manual for FY-30A use in the PTZ camera gimbal

In this example, the PTZ camera gimbal is two axis 360 degrees servo control,

which can rotate at any angle in pitch and heading. The servo output reduction gear.

FY-30A control module is installed inside the PTZ camera gimbal. The camera

gimbal is controlled by the operation of FY-30A own attitude and heading etc.

(shown as below).

Before connecting, please ensure the PTZ camera gimbal servo is normal. You

can do as follow to inspect: first, connect the PTZ camera gimbal servo to

coresponding RC receiver channel (for example, connect the pitch servo to the pitch

channel), then open the remote control, set all the channel fine tuning of RC

corresponding sticks to zero, and all of the curve set to default. After power on the

RC receiver, the PTZ camera gimbal servo won’t roll, and no pitching and rotation

etc. (shown as below)

Summary of content (4 pages)

PAGE 1
Guilin Feiyu Electronic Technology Co., Ltd. Operate manual for FY-30A use in the PTZ camera gimbal In this example, the PTZ camera gimbal is two axis 360 degrees servo control, which can rotate at any angle in pitch and heading. The servo output reduction gear. FY-30A control module is installed inside the PTZ camera gimbal. The camera gimbal is controlled by the operation of FY-30A own attitude and heading etc. (shown as below). Before connecting, please ensure the PTZ camera gimbal servo is normal.
PAGE 2
Guilin Feiyu Electronic Technology Co., Ltd. Connect one servo at each time, and testing them one by one. Be sure not to connect multiple at one time.(shown as below) If the servo continues rotation, the control servo stalling signal will be inconformity with RC default output neutral position. You can adjust fine tuning of the RC corresponding channel to compensation, until the servo stop rolling.
PAGE 3
Guilin Feiyu Electronic Technology Co., Ltd. You should set the DIP switch to the right position when control PTZ camera gimbal .(The DIP switch position is shown as below.) You will require a +5V battery to power on the RC receiver and FY-30A. After power on, when the RC stick is in the neutral position, the PTZ camera gimbal should keep the same attitude, that is to say, the servo will not roll.
PAGE 4
Guilin Feiyu Electronic Technology Co., Ltd. Under the condition of servo no rotation, you should control the PTZ camera gimbal with RC stick. If the servo shaking when the stick in the neutral position, that’s indicates the sensitivity is too big. As a result, you should slowly adjust the sensitivity knob to “middle” position, until the shaking situation disappear. After the PTZ camera gimbal servo and the FY-30A control sensitivity are all normal, you can record the neutral position.