User Manual

II How to use Summon
1. Function introduction of buttons and ports
1
Install battery
Power on:
Long press the function button
for 0.5 second for power on.
Power off:
Long press the function button
for 3 seconds for power off and
the indicator light turns off.
If the battery power is too low,
the screen shall turn off automatically,
please long press the function
button for 3 seconds so as to make
sure the unit completely powers off.
Then you can recharge or replace
the battery.
Remove the hand
shank and insert one
22650 battery into it.
Single tap this button to switch
below Photo mode and
Video mode.
Long press this button to open
WiFi function, and long press
again to turn off WiFi function.
The default is Video mode.
The function button on
control panel can control
power on and power off.
2
Power on and
power off
!
Connect to a computer
with USB data cable so
as to read the video and
picture files in a SD card.
SD reading port
Connect with USB data cable by this
port to upgrade firmware or charge
the battery.
Please refer to “Firmware upgrade”
for the operation of firmware upgrade.
Please refer to “Charging mode” for
the charging mode.
USB port
How to use Summon
2
Photo / Video
switchover button
USB port
Micro SD card *
(Equipped by users)
* Class10 high-speed micro
SD card is recommended