Installation Sheet

4 WWW.FEIT.COM
Retain this manual for future use.
Installation
2
Removing the fixture from the
mounting bracket
4
Attaching the mounting bracket to
the junction box in the ceiling
□ Identify the wires (Black-line voltage, White-neutral,
ground) from the ceiling and make them accessible for
easy connections.
□ Secure the bracket (AA) to the junction box using the
junction box screws (CC) provided.
x
Junction box
DD
□ Twist and unlock the mounting bracket (AA) from the
round LED flat panel (BB) fixture to remove.
1
Turning Off the Power
□ Turn the power OFF at the switch and
fusebox or the circuit breaker.
3
Identifying the wires
□ Use a pencil to mark the two hole positions for the plastic
anchors (DD) going in the ceiling.
□ Remove the bracket (AA) and install plastic anchors (DD) at the
marked locations. Use a 1/8 in. drill bit to make a hole and
insert a plastic anchor (DD) into each hole by tapping gently.
□ Screw the mounting bracket (AA) into the Junction box using
junction box screw (CC) and into the plastic anchor installed in
the ceiling using Anchor screw (EE) until secure.
AA
AA
AA
AA
BB
Ground
White
Black
CC
CC
EE
EE
CC
CC
Mounting hole
Mounting hole
NOTE: If securing the bracket with anchors is also desired,
follow the remaining steps in step 4. Otherwise, proceed to
step 5.