Model: UCL12FP/5CCTCAG2 DN ONE SYNC LED LIGHT SYSTEM = FLAT PANEL UNDER CABINET LIGHT FITS 12 IN. CABINETS (9 1/2 IN. TOTAL LENGTH) IMPORTANT SAFETY INSTRUCTIONS AND INSTALLATION GUIDE P EN READ BEFORE INSTALLATION SAVE THESE INSTRUCTIONS Questions, problems, missing parts? Before returning to the store, call Fe it Electric Customer Service 8am. 5 p.m.
Table of Contents Table of Contents . . .2 Safety Information Safety Information Save These Instructions IMPORTANT SAFEGUARDS: CAUTION: Dp not attempt to Install while plugged In. This ALWAYS FOLLOW BASIC SAFETY PRECAUTIONS WHEN USING ELECTRICAL urethra Js for Incisor use only. Not for use with plastic cabinets. Do not Install this fixture Inside 8 totally enclosed cabinet. Do not mount over stoves.
Pr-Assembly TOOLS REQUIRED PHILLIPS FLAT HEAD SCREWDRIVER ~~ SCREWDRIVER PENCIL HARDWARE INCLUDED PLIERS WRENCH A NOTE: Hardware not shown to actual size. QL i oc L188 ANG WIRE STEPPER ® HH Part | Description Quantity AA | 12in. LED Fiat Panel Fixture Linking Cable 1 eC Mounting Screws 2 DD Fixture Mounting Template 1 EE | Hardwired Bracket 1 FF Hardwired Bracket Screw 1 GG | Wire Nut 3 HH Clamp Connector 1 Maximum Sinkable Wattage input Maximum Sinkable Units with fem No.
Single LED Fixture Hardwired Installation 1 Tum off the Power Tum the power OFF from the breaker pane! before starting Installation. ® ] 5 Removing the Knock-out Carefully remove the knock-out with a Flathead screwdriver. 2 Position the Fixture Find the desired place for the LED light fixture and mark clearly using the provided mounting bracket template (DD).
Single LED Fixture Hardwired Installation (continued) 8 Wire Power Supply to the Fixture Feed the supply wire through the Clamp Connector (HH) and knockout hole and make all connections using the wire nuts provided. Connect the 120V line (black) wire to the black wire. Connect the neutral (white) wire to the white wire. Connect the ground (green) wire to the green wire. Fig.
Alternative Plug-In Installation (Electrical Pius not included) 1 Position the Fixtures Find the desired place for the LED light fixture and mark clearly using the provided mounting bracket template (DD). > 2 Installing the Mounting Screws Screw in the Mounting Screws (CC) en the marked locations, leaving a gap of inches between the screw head and the installation surface. a Marked locations AN GC 4 Connecting the Power Supply Plug In Electrical Plug to the LED Fixture (AA).
Operating Instructions ON/OFF and DIM Button ECT Button oF Use the ON/OFF and Dim Button for ON/OFF Operation and to Change the Dimming Levels [1 To select the desired dimming level, cycle through the dimming levels (High, Medium, Low, Dim, Off) by pressing the Dim Button. This setting well be fixed each time the ON/OFF switch Is muted ON. Changing the Color Temperature Setting [] To select the desired color temperature, cycle through 2700K 3000K 3500K 4000K 5000K by pressing the CGT Button.
