Use and Care Manual

FEIT ELECTRIC COMPANY | PICO RIVERA, CA | [phone] | FAX [phone] | www.feit.com
J-Box Mount Installation
MODEL S6AJWPK/850/BZ
WARNING: TURN OFF THE MAIN POWER AT THE CIRCUIT BREAKER BEFORE
INSTALLING THE FIXTURE IN ORDER TO PREVENT POSSIBLE ELECTRIC SHOCK.
1. Fully open lamp head by holding the housing
and lifting the lamp head (Fig A.)
2. Remove the two side screws and open the housing access
cover. Disengage the cover from the housing (Fig B).
3. Knock out the screw holes needed for the J-box on the
housing. Feed the power supply wires thru the center hole.
Mount the housing to the J-box (Fig C).
4. Connect the power supply wires to the wall light. Ground
to green, neutral to white and hot to black (Fig D).
5. Reattach the access cover and tighten the two side
screw. Adjust the lamp head to the desired angle (Fig E).
Fig A. Fig B.
Fig C.
Fig E.
Fig D.
Black
Green
White
WARNING: This luminaire should be installed by qualified electrician.
Remove
screws
J-box
Power
supply
wires
Knock
out