Use and Care Manual

FEIT ELECTRIC COMPANY | PICO RIVERA, CA | [phone] | FAX [phone] | www.feit.com
Wall Mount Installation
MODEL S5RWM/850/DD/BZ
WARNING: TURN OFF THE MAIN POWER AT THE CIRCUIT BREAKER BEFORE
INSTALLING THE FIXTURE IN ORDER TO PREVENT POSSIBLE ELECTRIC SHOCK.
WARNING: This luminaire should be installed by qualified electrician. To avoid the risk of fire, explosion or electric shock, this product
should be installed, inspected and maintained by a qualified electrician only, in accordance with all applicable electrical codes.
To avoid electric shock: Be certain electrical power is OFF before and during installation and maintenance. Luminaire must be connected
to a wiring system with an equipment-grounding conductor.
Make sure the supply voltage is the same as the rated luminaire voltage. Do not operate in ambient temperatures above those indicated on
the luminaire nameplate. Keep lens tightly closed when in operation.
1. Loosen the fixture set screws and remove the front cover
from the fixture housing. Unscrew the 2 screw nuts to
remove the crossbar (Fig A).
2. Pull the power supply wires to the side and install the fixture
crossbar onto the J -box with the screws provided (Fig B).
3. Using the wire nuts provided, connect the bare grounding wires
from the fixture to the house ground. Connect the white fixture
wire to the neutral house wire. Connect the black fixture wire to
the power supply wire (Fig C).
5. Position into place and secure the front cover into the fixture.
Install the housing by tightening the set screws (Fig E).
6. Caulk between the light fixture and the wall surface with a
silicone sealant (not included).
4. Adjust the crossbar fixture screws and tighten the center
swivel screws. Reattached the fixture housing to the crossbar
and tighten the screw nuts (Fig D).
Fig C. Fig D.
Fig E.
Fig B.
Fig A.
Front
cover
Fixture
housing
Crossbar
Fixture
set screw
Screw
nuts