Use and Care Manual

FEIT ELECTRIC COMPANY | PICO RIVERA, CA | [phone] | FAX [phone] | www.feit.com
Wall Mount Installation
MODEL S10WPK/850/DD/BZ
WARNING: TURN OFF THE MAIN POWER AT THE CIRCUIT BREAKER BEFORE
INSTALLING THE FIXTURE IN ORDER TO PREVENT POSSIBLE ELECTRIC SHOCK.
WARNING: This luminaire should be installed by qualified electrician. To avoid the risk of fire, explosion or electric shock, this product
should be installed, inspected and maintained by a qualified electrician only, in accordance with all applicable electrical codes.
To avoid electric shock: Be certain electrical power is OFF before and during installation and maintenance. Luminaire must be connected
to a wiring system with an equipment-grounding conductor.
Make sure the supply voltage is the same as the rated luminaire voltage. Do not operate in ambient temperatures above those indicated on
the luminaire nameplate. Keep lens tightly closed when in operation.
1. Remove the front cover from the back plate by unscrewing the
2 side screws on the front cover. Then remove the crossbar from
the back plate by unscrewing the 2 nuts holding the crossbar (Fig A).
3. Connect the power supply wires to the fixture, ground to green,
neutral to white and hot to black. Feed the wires into the J-box (Fig C).
2. Make sure power is off. Mount crossbar onto J-box (Fig B).
Fig A.
Fig B.
Fig C.
Fig D.
Fig E.
Front cover
Back plate
Crossbar
Nuts
Screws
4. Mount back plate onto the crossbar. Hand tighten
the nuts to secure back plate (Fig D).
Back plate
Nuts
J-box
Crossbar
5. Mount front cover and screws onto the back plate.
Hand tighten the screws with a screw driver. Caulk
between the fixture and the wall surface with
silicone sealant (not included) (Fig E).
Screws
Front cover