Use and Care Manual

FEIT ELECTRIC COMPANY | PICO RIVERA, CA | [phone] | FAX [phone] | www.feit.com
Ceiling Installation
MODEL S10VCM/850/GRY
WARNING: TURN OFF THE MAIN POWER AT THE CIRCUIT BREAKER BEFORE
INSTALLING THE FIXTURE IN ORDER TO PREVENT POSSIBLE ELECTRIC SHOCK.
Fig A.
Fig B.
Fig C.
Fig D. Fig E.
WARNING: This luminaire should be installed by qualified electrician.
LED Housing
Round J-Box
Screw
Glass Guard
LED Glass Cover
2. Loosen the two screws on the round J-Box that is
securing the LED housing. Turn the LED housing to
allow screws to exit through the keyholes (Fig B).
3. Using the two tabs, mount the round J-Box
on the desired surface area. Use appropriate
hardware (not included) (Fig C).
4. Supply power to the J-Box by using the
appropriate conduit (not included). Using
the wire nuts provided, connect the
green wire to the house ground, white
wire to the neutral and the black wire to
the power supply wire. Connect all wires
per all applicable codes (Fig D).
5. Align the LED housing keyholes to the
J-Box screws. Turn the LED housing to
the secure position and tighten the
screws. Screw the LED glass cover into
the LED housing, lock the glass guard
back into the LED housing and secure it
by tightening the side scew on the glass
guard (Fig E).
Note: Make sure to reinstall the gaskets between the
parts when putting the fixture back together.
1. Remove the glass guard by loosening the side screw,
turn the glass guard to remove it and unscrew the
LED glass cover (Fig A).
Front View
Screws