Installation Instructions

ManualsBrandsFeit Electric ManualsIndoor Lighting5" & 6" 65W Equivalent Warm White Dimmable LED Flat Panel Recessed Retrofit Kit

FEIT ELECTRIC COMPANY | PICO RIVERA, CA | (800) 543-3348 | FAX (562) 908-6360 | www.feit.com

USE AND CARE GUIDE

5-6 INCH WHITE ROUND FLAT PANEL DOWNLIGHT

LEDR56FP/830

Summary of content (6 pages)

PAGE 1
LEDR56FP/830 USE AND CARE GUIDE 5-6 INCH WHITE ROUND FLAT PANEL DOWNLIGHT FEIT ELECTRIC COMPANY | PICO RIVERA, CA | (800) 543-3348 | FAX (562) 908-6360 | www.feit.
PAGE 2
Table of Contents Table of Contents. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Safety Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Warranty. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Pre-Installation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
PAGE 3
Pre-Installation TOOLS REQUIRED Phillips screwdriver HARDWARE INCLUDED NOTE: Hardware not shown to actual size. AA FF BB GG CC HH DD II JJ EE KK LL Part Description Quantity AA 7.5 in. fixture 1 BB Mounting bracket 1 CC 5 & 6 in. Torsion spring brackets 2 DD E26 adapter with male connector 1 EE Stripped wires with male connector 1 FF 5 & 6 in. Torsion springs 2 DISTANCE CENTER BEAM (FOOT CANDLES) BEAM DIAMETER GG Ground wire 1 3 FT. 40 8.6 FT.
PAGE 4
5-6 in. Recessed Can Installation 4 Adjusting the torsion springs 1 Turning Off the Power □□ Turn the power OFF at the switch and fusebox or the circuit breaker. □□ Remove the existing trim installed in the recessed housing. □□ Insert the torsion springs into the fixture housing brackets. □□ When installing trim into a 5 in. recessed housing, the torsion spring (FF) must be moved. Unscrew the torsion spring (FF) from the 6 in. position and move it to the 5 in. position. (Fig. 3) Fig.
PAGE 5
J-Box Installation 1 3 Turning Off the Power □□ Turn the power OFF at the switch and fusebox or the circuit breaker. □□ Remove the existing trim installed in the recessed housing. 2 Identifying the wires □□ Identify the wiring: (black - line voltage, white - neutral and green - ground) □□ Use the wire nuts (JJ) to connect the stripped wires with male connector (EE) to the two wires coming from the J-box (black - line voltage, white - neutral). □□ Determine if the ground wire is inside the J-box.
PAGE 6
J-Box Installation (continued) 5 Connecting the terminals □□ Connect the two terminals together. (Fig. 8) Fig. 8 Connect the orange connectors 6 Installing the fixture □□ Secure the fixture (AA) to the mounting bracket (BB) by pressing the fixture into the mounting bracket until the clips on the fixture engage together. Make sure the fixture is firmly locked into place. (Fig. 9) Fig. 9 BB AA 6 WWW.FEIT.COM Retain this manual for future use.