Bo ELECTIVE Replace with LEDR56B/927CA/MP/6 type LED light. To order contact FAT ELECTRIC COMPANY Tel: 562-463-2852 HTTP: www. forfeit Email: Version 2.0 INSTALLATION & OPERATING INSTRUCTIONS READ & SAVE IMPORTANT SAFETY INSTRUCTIONS Please read and understand this entire manual before attempting to assemble, operate or install this product. 1.
Version 2. 0 PACKAGE CONTENTS Before beginning installation of this product, make sure all parts are present. Compare parts with package contents list and diagram as below. If any part is missing or damaged, do not attempt to assemble, install or operate this product.
Version 2. 0 1. Installation into Existing Recessed Incandescent Fixture: For use with 6” OR 5" recessed housings (housing sold separately) LED recessed trim will fit into select existing 6” or 5" nominal incandescent housings. Step 1. Turn OFF power at switch and fuse box or circuit breaker. Step 2. Remove existing trim installed in recessed housing (if necessary). Step 3. If applicable, slide lamp holder bracket to its upward maximum position. If the lamp holder bracket is less than 4.
Version 2. 0 Step 6. Connect the orange connectors together (see FIG. 4B). Step 7. Insert torsion springs into fixture housing brackets (see FIG. 5). Step 8. When installing trim inch a 5” recessed housing, the torsion spring must be moved. Unscrew the torsion spring from the 6” position and move to the 5” position as shown. Step 9. Gently push up trim and torsion springs so they begin to expand and lift trim in place (see FIG. 6). FIG. 4A FIG. 5 FIG. 4B FIG.
Version 2. 0 2. Installation into Existing Recessed LED Fixture with compatible orange connectors LED recessed trim will fit into select existing nominal LED housings, Step 1. Turn OFF power at switch and fuse box or circuit breaker. Step 2. Remove existing trim installed in recessed housing (if necessary). Step 3. Discard medium base adapter Step 4. Connect the orange connectors together (see FIG. 2B). Step 5. Insert torsion springs inch fixture brackets (see FIG. 2A). Step 6.
Version 2. 0 ‘WARNING Risk of fire or electric shock. LED Recessed Downright installation requires knowledge of luminaries electrical systems. If not qualified, do not attempt installation. Contact a qualified electrician. ‘WARNING Risk of fire or electric shock. Install this product only in the luminaries that have the construction features and dimensions shown in the photographs and/or drawings. Do not make or alter any open holes in an enclosure of wiring or electrical components during installation.