User Guide

WWW.FEIT.COM
5
Operation with Remote (sold separately)
Operating with a OneSync remote allows for expanded control. Modify settings of individual OneSync fixtures or multiple fixtures in groups.
The OneSync Remote has a 100ft control range and will command all paired fixtures within 100ft of the remote.
All OneSync fixtures are equipped with a signal repeater that will repeat any remote commands to all other fixtures within 100ft. Placing
fixtures within 100ft of at least one other fixture creates a control network and allows for unlimited remote control range, as long as there is a
functioning OneSync fixture within 100ft to relay the command.
Entering pairing mode
□
Hold down the pairing button for 3 seconds. Once the bollard light (AA)
starts to blink slowly it is in pairing mode. The bollard light (AA)
remains in pairing mode for three minutes before timing out.
1
Pairing the remote to the fixture
□
While the bollard light (AA) is in pairing mode, press and hold
the desired Groups button (1, 2, 3, 4, 5 or 6) for 3 seconds to pair
the remote to the selected group.
The light will flash once, and the fixture will exit pairing mode.
2
Unpairing the fixture from the remote
□
To unpair, first follow step 1 so that the fixture is in pairing mode. Once the fixture is in
pairing mode, on the OneSync remote, press the pairing group button and hold the power
button for 3 seconds. The light will flash once and the fixture will exit pairing mode.
□
The light will flash once, and the fixture will exit pairing mode.
□
To unpair from all groups at once, hold down button on the OneSync fixture for 10 seconds.
It will flash three times rapidly to indicate that that all groups have been unpaired from the fixture.
3
Battery Replacement
Replacing the battery
□
To replace the rechargeable battery, remove the lid on the side of the bollard light (AA)
by unscrewing the lid screws (2) using a Phillips head screwdriver.
□
Replace current lithium-ion battery with a new lithium-ion 18650 2200mAh 3.7V
minimum 8.14Wh only.
Install battery correctly with regard to the polarity (+ and -).
□
Reattach (the lid) by lining up the rivet on the inside of the lid with the corresponding
opening on the base (located directly above the On/Off button). Once lid is resting
squarely on the base, insert and tighten the (2) screws using a Phillips head screwdriver.
1
NOTE: The remote comes equipped with a universal Group #1. To create unique groups, pair using Groups #2-6.
All fixtures are pre-paired to the universal Group #1 so that they will immediately respond with any remote
Group #1 command. To not operate on this universal group, follow the unpairing instructions in Step 3.
On/Off
Select Group
Colors Cycle
Brightness
Level
Selectable
White Color
Cycle
Set Daily Timer
OneSync Remote
1 2 3
4 5 6
2hr 4hr 8hr
Timer
Reset
Groups
LOW HIGH
RGB
Ex) You can install a OneSync fixture, then another OneSync fixture 100ft away from the first unit. Continue to install 3 more OneSync fixtures
in this way so that the last fixture is 500ft away. Using this relay technology, the remote will control the farthest fixture that is 500ft away.
AA