User Guide

On/Off/Cycle
&
Pairing Button
IMPORTANT: Do not push on the bollard
light (AA) or you may damage the device.
Bollard Light Installation
Installing the stake
□
Push the ground stake (CC) into the ground. Using rubber mallet, insert ground stake (CC) deep enough into the
ground to ensure fully assembled bollard light (AA) is stable and does not tip over.
1
Installing the bollard light
□
Align the bollard light (AA) with the slot on the 7 in. pole (BB). Slide the bollard light (AA)
downward then turn clockwise.
□
Slide the bollard light (AA) downward until it sits squarely on the stake.
□
Rotate the bollard light (AA) clockwise to lock in.
2
CC
CC
BB
4
WWW.FEIT.COM
Removing the insulating tab
□
The light will not operate without pulling out the insulating tab.
3
Operation without Remote
Turning on the fixture
□
Turn the on bollard light (AA) by pressing the on/pairing
button on the side of the fixture.
□
Light can only turn On and stay On at nighttime.
1
This OneSync fixture works individually or with remote/smart bridge for grouping and expanded control.
DUSK TO DAWN OPERATION: The light will automatically turn on at dusk and remain on through the night for 6 hours. The light will remain off
throughout the day, until dusk. NOTE: To make sure this function works properly, always have the switch in the ‘ON’ position (including daytime).
Selecting a Color
□
To cycle through the colors, push the button.
□
Colors are: Soft White, Bright White, Cool White, Daylight,
Deluxe Daylight, Red, Blue, Green, Yellow, Orange,
Purple, Teal, and Pink.
□
The bollard light (AA) will remember the color setting
when next turned on.
2
NOTE: When installing product in hard or dry
soil, water the soil several hours beforehand to
make the installation easier. You can also
break up the ground lightly with a stake or a
fork. Don’t force stake into the ground as
excess force can break or bend the stake.
AA
BB
AA