74206/CA USE AND CARE GUIDE 5-6 INCH WHITE ROUND FLAT PANEL DOWNLIGHT WITH SELECTABLE COLOR TEMPERATURES FEIT ELECTRIC COMPANY | PICO RIVERA, CA | (800) 543-3348 | FAX (562) 908-6360 | www.feit.
Table of Contents Table of Contents. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Safety Information. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Warranty. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Pre-Installation. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Pre-Installation TOOLS REQUIRED Phillips screwdriver HARDWARE INCLUDED NOTE: Hardware not shown to actual size. AA FF BB GG CC HH DD II JJ Part Description Quantity AA 7.5 in. fixture 1 BB Mounting bracket 1 CC 5 & 6 in. Torsion spring brackets 2 DD E26 adapter with male connector 1 EE Stripped wires with male connector 1 FF 5 & 6 in. Torsion springs 2 GG Ground wire 1 HH Ground wire screw 1 II J-Box mounting screws 2 JJ Wire nuts 3 KK 5 & 6 in.
5-6 In. Recessed Can Installation 1 2 4 Turning Off the Power □□ Turn the power OFF at the switch and fusebox or the circuit breaker. □□ Remove the existing trim installed in the recessed housing. Connecting the terminals □□ Connect the two terminals together (See Fig. 3). Fig. 3 Choosing a color temperature before installing Connect the orange connectors 5 □□ Use the slide switch to choose a color temperature before installing.
J-Box Installation 1 3 Turning Off the Power □□ Identify the wiring: (black - line voltage, white - neutral and green - ground) □□ Turn the power OFF at the switch and fusebox or the circuit breaker. □□ Remove the existing trim installed in the recessed housing. 2 Identifying the wires □□ Use the wire nuts (JJ) to connect the stripped wires with male connector (EE) to the two wires coming from the J-box (black - line voltage, white - neutral). □□ Determine if the ground wire is inside the J-box.
J-Box Installation (continued) 5 7 Installing the mounting bracket to the junction box Installing the fixture □□ Secure the fixture (AA) to the mounting bracket (BB) by pressing the fixture into the mounting bracket until the clips on the fixture engage together. Make sure the fixture is firmly locked into place (See Fig. 8). □□ Install the mounting bracket (BB) to the J-box by inserting the two mounting screws (II) through the slots in the mounting bracket (BB).
Changing the Color Settings NOTICE: The toggle switch is located on the back of the fixture. 4-way color changing: 1. You can lock in one color temperature, change among multiple color temperatures, dim from 10%100%, memorize the last color temperature and reset automatically. 2. Light Switch Marks on the lamp represent: SW (Soft White) - BW (Bright White) - DL (Daylight) - Switch (Light Switch) 3. When the slide switch is set to SW (Soft White), the color temperature is set at 3000K. 4.
