Instructions / Assembly

FEIT ELECTRIC COMPANY | PICO RIVERA, CA | [phone] | FAX [phone] | www.feit.com
Remove the fixture and the mounting
package from the box and make sure that
no parts are missing by referencing the
illustrations on the installation instructions.
MODELS 73802
1. Outlet Box (not included)
2. Mounting Plate (1 piece)
3. Outlet Box Mounting Screws (2 pieces)
4. Fixture Mounting Screws & Nuts (2 pieces)
5. Fixture Ground Wire
6. White Fixture Wire
7. Black Fixture Wire
8. Wire Nut (3 pieces)
9. Glass Shade (3 pieces)
10. Glass Shade Fastener (3 pieces)
11. Finial (2 pieces)
12. Fixture Housing (1 piece)
13. Glass Holder
14. LED Module
LED VANITY FIXTURE INSTRUCTIONS
GENERAL
All electrical connections must be in accor-
dance with local and National Electrical Code
(N.E.C.) standards. If you are unfamiliar with
proper electrical wiring connections obtain
the services of a qualified electrician.
Remove the fixture and the mounting package
from the box and make sure that no parts are
missing by referencing the illustrations on the
installation instructions.
CAUTION
TURN OFF THE MAIN POWER
AT THE CIRCUIT BREAKER
BEFORE INSTALLING THE
FIXTURE, IN ORDER TO
PREVENT POSSIBLE SHOCK.
PARTS INCLUDED:
Carefully unpack and unwrap fixture and
glass shades.
Check that black (7), white (6) and ground
wire(s) (5) are extending from the back of
the fixture. Remove GLASS SHADES (9) if
attached to fixture. Before wiring fixture to
the power supply, turn off electricity at fuse or
circuit breaker box. Fixture must be grounded
to avoid potential electrical shock and to
ensure reliable lamp starting.
Insert the FIXTURE MOUNTING SCREWS (4)
into the MOUNTING PLATE (2) and secure
by tightening included NUTS (4) against the
Mounting Plate. NOTE: Make sure MOUNTING
SCREWS (2) do not protrude too much or too
little from the Mounting Plate. You may need
to adjust them to proper length. Once proper
1
2
3
5
4
6
7
MOUNTING INSTRUCTIONS
SAVE THESE INSTRUCTIONS.
length is determined, tighten with nut to secure
screws against Mounting Plate.
Mount Mounting Plate (2) to OUTLET BOX (1)
by inserting the two MOUNTING SCREWS (3)
through slots in Mounting Plate.
Lift fixture housing to outlet box. Using wire nuts
(8) provided connect green wire (5) from fixture
to green or bare copper ground (house) wire. If
outlet box is grounded you may fasten fixture
ground wire directly to outlet box. Connect white
fixture wire(s) (6) to neutral supply wire. Connect
black fixture wire(s) (7) to power supply wire.
Insert FIXTURE MOUNTING SCREWS (4) through
fixture housing (12) holes and secure by hand
tightening the FINIALS (11) to the ends of the
FIXTURE MOUNTING SCREWS (4).
NOTE: Hand tighten finials only. Do not use any
tools as overtightening may occur causing
damage to fixture housing.
Slide the GLASS SHADE (9) into the GLASS
HOLDER (13) and secure by screwing GLASS
SHADE FASTENER (10) onto GLASS HOLDER (13).
Repeat step for the remaining GLASS SHADES (9).
Hand tighten only.
READ IMPORTANT SAFETY INFORMATION FIRST ON REVERSE SIDE OF THIS SHEET.
1
4
2
3
5
8
7
11
10
6
13
14
12
9