Installation Guide

ManualsBrandsFeiss ManualsLightingArramore Dark Weathered Zinc Integrated LED Hanging Pendant

Installation Instructions for

GP I :ENERAL RODUCT NFORMATION

These fixtures are intended to be installed utilizing compliantNEC

junction boxes.

This product is safety listed for damp locations.

For a complete list of dimmers, visit out website at www.Feiss.com

Determine the height of the fixture with the provided stems and assemble them by screwing them together.

Secure the mounting plate to the junction box.

Feed the fixture wires through the stems and screw the stem assembly to the pendant.

Feed the fixture wires through the canopy and screw the canopy onto the stem assembly.

Connect the fixture to a suitable ground in accordance to local electrical codes.

Connect the white fixture wire to the neutral power line wire with a wire nut.

Connect the black fixture wire to the hot power line wire with a wire nut.

Neatly place the wires into the junction box and/or canopy, then place the canopy onto the mounting plate and secure it in

place with the fixture screws.

PENDANT

CAUTION RISK OF FIRE-

This product must be installed in accordance with

the applicable installation code by a person familiar

with the construction and operation of the product

and the hazards involved.

Use minimum 90°c supply conductors.

FIXTURE SCREW

MOUNTING

PLATE

CANOPY

STEM

Arramore Outdoor Mini-Pendant ( )LED

1.0

P1419-LED

Pendant

P1419-LED

Summary of content (4 pages)

PAGE 1
Installation Instructions for P1419-LED Arramore Outdoor Mini-Pendant (LED) P1419-LED 1.0 Pendant GENERAL PRODUCT INFORMATION: CAUTION - RISK OF FIRE This product must be installed in accordance with the applicable installation code by a person familiar with the construction and operation of the product and the hazards involved. These fixtures are intended to be installed utilizing NEC compliant junction boxes. This product is safety listed for damp locations. Use minimum 90°c supply conductors.
PAGE 2
ATTENTION : RISQUE D'INCENDIE Ce produit doit être installé conformément au code d'installation en vigueur par une personne familière avec la construction et l'exploitation du produit et les risques qu'il entraîne. Utiliser les conducteurs d'alimentation supérieure à 90° c. 1A PLAQUE DE MONTAGE 7 6 VIS DE LUMINAIRE 8 8 DAIS 4 1 1 TIGE 1 1 3 PENDENTIF 1 Déterminer la hauteur du luminaire avec les connecteurs et assembler en les vissant ensemble.
PAGE 3
PRECAUCIÓN: RIESGO DE INCENDIO Este producto debe instalarse de acuerdo con el código de instalación aplicable por una persona familiarizada con la construcción y operación del producto y los riesgos que conllevan. Utilizar conductores de suministro mínimo 90° c. 1A PLACA DE MONTAJE 7 6 8 TORNILLO DE LA LÁMPARA 8 DOSEL 4 1 1 TALLO 1 1 3 COLGANTE 1 Determinar la altura de la lámpara con los tallos proporcionados y ensamblarlos atornillándolos juntos.
PAGE 4
SAVE THESE INSTRUCTIONS! 7400 Linder Ave, Skokie, IL 60077 800.969.3347 www.Feiss.com © 2016 Feiss.All rights reserved.The "Feiss" graphic is a registered trademark of Feiss. Feiss reserves the right to change specifications for product improvements without notification.