Manualshelf

Installation Sheet

ManualsBrandsFeiss ManualsCeiling LightsHarrow Burnished Brass Modern/Contemporary Clear Glass Dome Pendant Light
12
1
Installation Instructions for
Harrow 1 and 3 Light Pendant
1.3
P1288-P1289
P1288, P1289
If necessary, screw the short end of the threaded nipple tightly onto the mounting plate and the screw collar onto the threaded
nipple.
Secure the mounting plate to the junction box.
Temporarily place the fixture upside down on a flat surface.
Remove the cap nuts, plate, threaded studs, brackets, and socket assembly from the fixture frame.
Install the glass panels by sliding them into the fixture frame.
Reinstall the socket assembly, brackets, threaded studs, plate, and cap nuts (in that order), then place the fixture right side up.
Screw the fixture loop onto the socket assembly’s threaded pipe to secure it in place.
Determine the wanted height of the fixture and remove a portion of the chain from the bottom by opening a link with pliers.
Install the large quick link to bottom end of the chain, then secure the quick link onto the fixture loop.
Unscrew the collar nut from the screw collar, then install the collar nut, and the canopy onto the chain (in that order).
Install the small quick link onto the remaining end of the chain, then secure the quick link onto the screw collar
Weave the cord through the chain, collar nut, canopy, screw collar, threaded nipple, and out of the junction box. Trim the cord leaving
enough to make electrical connections.
Connect the fixture to a suitable ground in accordance to local electrical codes.
Connect the white fixture wire (square and/or rigid) to the neutral power line wire with a wire nut.
Connect the black fixture wire (round and/or smooth) to the hot power line wire with a wire nut.
Neatly place all the wires into the junction box, place the canopy onto the mounting plate, and secure it in place by screwing the
collar nut onto the screw collar.
Screw the lamp(s) into the socket(s). Refer to the label on the lamp socket for Max Wattage information.
1A
LAMP
FIXTURE FRAME
THREADED PIPE
SOCKET ASSEMBLY
PLATE
CAP NUT
THREADED
STUD
GLASS
PANEL
BRACKET
17
5
FIXTURE LOOP
Pendant
CAUTION RISK OF FIRE-
This product must be installed in accordance with the
applicable installation code by a person familiar with the
construction and operation of the product and the hazards
involved.
Use minimum 90°c supply conductors.
GP I :ENERAL RODUCT NFORMATION
These fixtures are intended to be installed utilizing NEC compliant junction
boxes.
This product is safety listed for damp locations.
Incandescent lamps may be dimmed with a standard incandescent dimmer.
LED lamps may be dimmed with a LED dimmer. Consult lamp manufacturer
for additional information.
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
15
14
COLLAR NUT
CHAIN
THREADED NIPPLE
MOUNTING PLATE
SCREW COLLAR
LARGE QUICK LINK
JUNCTION BOX
SMALL QUICK LINK
CANOPY
17
9
11
16
17
7

Summary of content (2 pages)