Installation Guide

(E) 4/07
ASSEMBLY INSTRUCTIONS FOR OL5413
Bulb
(not included)
Glass Plate
IMPORTANT
TURN OFF THE POWER AT THE MAIN FUSE
OR CIRCUIT BREAKER BOX
BEFORE STARTING INSTALLATION
Lock Washer
Rubber Washer
Coupler
Finial
Carefully unpack and identify all parts before
assembly. Bulb is not included.
1. If you are replacing an existing fixture, disconnect
and remove the old fixture. Expose the supply
wiring from the outlet box.
2. Screw the small threaded pipe 3 complete turnsinto
the flat side of mounting strap and lock inplace
with hex nut.
3. Fasten the mounting strap to the outlet box using
the two screws supplied with the outlet box.
4. Spread the electrical wires so that the black wires
are on one side of the outlet box and the whitewires
are on the other side.
5. Grounding Connection:
  This fixture is provided with a ground wire.
Connectfixture ground wire to ground wire from
outletbox with wire connector (not provided).

  Never connect ground wire to black or white supply
wires.
6. To make electrical connections:
 Connect the white wire(s) from the fixture to the
white wire of the outlet box. Connect the black
wire(s) from the fixture to the black wire of the
outlet box. NOTE: Black outlet box wire may be
red, round & smooth and/or have copper conductor.
White outlet box wire may be square & ridgedand/
or have a silver conductor.
7. Place fixture through short threaded pipe so that
fixture sits flushagainst ceiling. Be sure all wires
are inside fixture. Secure fixture to ceiling by
screwing coupler onto small threadedpipe. Coupler
must turn at least 3 times, if it does not youmust
lengthen threaded pipe accordingly.
8. Install bulbs (not included). See relamping label
located atsocket area for type and maximum
allowed wattage.
9. Install a hex nut onto one end ofthreaded pipe
leaving about 1/2"(13mm) thread exposed. Screw
same end of threaded pipe intocoupler. Tighten hex
nut.
10.Carefully slip glass platethrough same pipe until it
tucks into bottom of fixture.Then slip rubber
washer and secure all together byfastening with
finial. IMPORTANT: Do not over tightenfinial.
Supply
Ground Wire
Mounting Strap
Short Threaded Pipe
Long Threaded Pipe
Outlet Box
Mounting Screws
(not supplied)
Fixture
Ground Wire
Fixture
Wire
Fixture
Supply Wire
Outlet Box Ceiling