User's Manual

Loading
36
2. Close the flow cell compartment door.
3. Tap Post-wash and a confirmation message appears. Select Yes to
start post-washing.
¾
Tap , and a confirmation message appears. Select Yes to
pause the wash. Tap again to resume the wash.
¾
Tap , and a confirmation message appears. Select Yes to
stop the wash.
4. When the wash is complete, take out all the consumables by
following the on-screen instructions.
5. Tap Finish to return to the main interface A.
6. Store the washing flow cell at the room temperature.
The washing flow cell can be reused for up to three times
for washing. Then, dispose of the flow cell according to local
regulations and safety standards of your laboratory.
7. Empty any remaining washing solution in the post-loading
plate into an appropriate waste container. Dispose of the waste
according to local regulations and safety standards of your
laboratory.
Used post-loading plate can be used as washing plate after you
clean the plate with laboratory water for three to five times. Then
we recommend that you dispose of the plate after three months
of continuous use.
8. Dispose of the DNB tube according to local regulations and safety
standards of your laboratory.