Installation Manual

OBID i-scan
®
Installation ID ISC.ANT1690/600-A/-B
FEIG ELECTRONIC GmbH Page 16 of 41 M91200-1e-ID-B.doc
5.2 Gate Configuration and Setup using Antennas Type –A and -B
5.2.1 Required Components
To set up the gate you need the following components:
- Qty. 1 ID ISC.ANT1690/600-A Crystal Gate
- Qty. 1 ID ISC. ANT1690/600-B Crystal Gate
- Qty. 1 ID ISC.NET24V-B Power Supply Unit
- Power cable, interface cable and connection cable for the DC power supplies (2-wire,
twisted)
- Mounting materials (screws, anchors)
To calibrate the Reader you will need the software
- ISOStart Version 8.02 or higher
and for tuning the antennas the service software
- DATuningTool Version 1.00 or higher
on a personal computer running under Microsoft
®
Windows
®
. The service can be downloaded at
the Download Area of the Homepage www.feig.de
.