Installation Manual

OBID i-scan
®
Installation ID ISC.ANT1690/600-A/-B
FEIG ELECTRONIC GmbH Page 6 of 41 M91200-1e-ID-B.doc
2 Maintenance
The antenna ID ISC.ANT1690/600 is a design product with high quality surfaces, and should al-
ways be handled with caution. The antenna was designed to work reliably and flawlessly for years
without special maintenance.
Attention! The surfaces should be cleaned with a clean, soft cloth dampened in a
dishwashing liquid – water solution. The use of alcohol, spirit, thinners, glass clean-
ers or other harsh cleaning liquids is prohibited and will damage the acrylic plate.
To improve the durability and the appearance, please follow the instructions below:
• Keep the antenna clean and take caret the antenna is not scratched. Also regularly apply specific
antistatic products for Acrylic Surfaces.
• Regularly remove dust and other impurities with a soft cloth and a solution of water with a little
dishwashing liquid.
• Keep the antenna dry. All kinds of moisture should be avoided during operation and storage.
Precipitation, humidity and liquids contain minerals that will corrode electronic circuits and da-
maging transparent plastic parts.
• Protect the antenna from high temperatures. Mount the antenna away from heaters and other
heat sources. Operation under direct sunlight can cause extreme high temperatures and a fad-
ing cause of the surface.
• Avoid storing or operating the antenna at dirty or wet locations. The surfaces or electronic
components may be-damaging.
• Handle the device with care. Shocks may break internal circuit boards.
• Do not try to open the antenna during operation or outside maintenance periods. Non-
professional management can result in damage to the device.
If any device not working properly, please contact the appropriate representative.