User's Manual
Table Of Contents
- Sicherheits- und Warnhinweise - vor Inbetriebnahme unbedingt lesen
- Leistungsmerkmale des Readermoduls ID ISC.M02
- Montage und Anschluss
- Funkzulassungen
- Technische Daten
- Safety Instructions / Warning - Read before start-up !
- Performance Characteristics of the ID ISC.M02 Reader Module
- Installation and wiring
- Radio Approvals
- Technical Data
OBID
®
Installation ID ISC.M02
FEIG ELECTRONIC GmbH Page 30 of 42 M20301-0de-ID-B.doc
E N G L I S H
8.2.1. Supply voltage
The ID ISC.M02-A/B must be supplied only by a regulated power supply.
If switching power supplies are used with the module, be sure that there is adequate filtering.
Noise from the power supply can result in a reduction of the read/write range of the module.
The cable length from the power supply should be as short as possible, and should in any case not
exceed 3 m.
Description
X1
Pin no.
Function
ID ISC.M02-B
8 VCC *
+ 5 V DC ± 5%
9, 4 GND ** GND
* Use only regulated power supplies !
** GND-Pins 4 and 9 are to be connected directly to each
other on the Reader Module
Table 3.2.1-1: Pin assignments for X1
NOTE:
• Reversing the polarity of the supply voltage may destroy the device.
• Supply voltages outside the specifications may destroy the device.