User Guide

OBID
®
classic-pro
Installation
ID CPRPOS
FEIG ELECTRONIC GmbH Page 9 of 18
ID CPRPOS User Manual-01.doc
4.1. Ethernet interface
The ID CPRPOS has an integrated 10/100 base-T network port with a common RJ-45 connector
and an automatic “crossover correction”.
With structured cabling CAT5 cables should be used. This ensures a reliable operation at 10 Mbps
and 100 Mbps.
The prerequisite for using TCP/IP protocol is that each device has a unique address on the net-
work. All readers have a factory set IP address. The communication parameter could be configured
user-defined.
Table 2: Standard factory configuration of the ethernet interface
Network Address
IP address 192.168.10.10
Subnet mask 255.255.0.0
Port 10001
DHCP OFF
NOTE:
• The reader is equipped with a DHCP ready ethernet interface.
• It is recommended to use a screened STP (shielded twisted pair) CAT5 cable.