User's Manual

OBID
®
classic-pro Installation ID CPR.M02/ANT19
FEIG ELECTRONIC GmbH Page 20 of 20 Manual-M21001-3de-ID-B.doc
4. Radio Approvals
4.1. Europe (CE)
When used according to regulation, this radio equipment conforms with the basic requirements of
Article 3 and the other relevant provisions of the R&TTE Guideline 1999/E6 dated March 99.
Equipment Classification according ETSI EN 300 330: Class 2
4.2. USA (FCC)
FCC ID PJMCPRM02-ANT19
This device complies with Part 15 of the FCC Rules. Operation is subject to the following
two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may
cause undesired operation.
Any changes or modifications not expressly approved by the party responsible for com-
pliance could void the user's authority to operate the equipment.
This device is labeled with an FCC ID number.
If this label is not visible when installed in an end device, the outside of the device MUST
also display a label referring to the enclosed module.
Wording on the label similar to the following shall be used:
This device contains transmitter module FCC ID PJMCPRM02-ANT19
At the time of this printing, the antennas listed below were the only antennas approved for
use with the ID CPR.M02 module. Use of other antennas must be approved by
FEIG ELECTRONIC GmbH.
Antennas approved: ID ISC.ANT19
The FCC sticker is glued at the package.
ID CPR.M02/ANT19
FEIG ELECTRONIC
FCC ID PJMCPRM02-ANT19