User's Manual

OBID
®
classic-pro Installation ID CPR44
FEIG ELECTRONIC GmbH Page 10 of 16 ID CPR44 User Manual-
01.doc
3.4.1. Installation of a SAM Card
The following step by step instruction shows the installation of the SAM Card 1 and 3 into the SAM
connector X4. The installation of the SAM Cards 2 and 4 in the socket X5 must be done in the
same way.
1. Unlatch the top cover at the front edge. 2. Push the cover of lower slot backwards and
open it
3. Put the SAM module 1 into the cover of the
lower slot. The contact plate face down
4. Turn down the cover of the lower slot and
push it forward till the cover is locked.
5. Place the SAM Cart 3 with the contact face at
the top on the cover of the lower slot.
6. Close the top cover with carefully pressure to
snap into place.