User's Manual

ManualsBrandsFeig Electronic ManualsElectronicsTag Reader

Table Of Contents

OBID

classic-pro INSTALLATION ID CPR40.30

FEIG ELECTRONIC GmbH Page 8

Radio Approval Europe

USA

EN 300 330

FCC 47 CFR Part 15

Elektromagnetische Verträglichkeit / EMC EN 301 489

Sicherheit / Safety Niederspannung / Low Voltage

Human Exposure

EN 60950

EN 50364

Umwelt und Stoffverbote / Waste and Hazardous

Substances

WEEE - 2002/96/EC

RoHS - 2002/95/EC

Die Funkanlage entspricht, bei bestim-

mungsgemäßer Verwendung den grundlegenden

Anforderungen des Artikels 3 und den übrigen ein-

schlägigen Bestimmungen der R&TTE Richtlinie

1999/5/EG vom März 99.

Equipment Classification gemäß

ETSI EN 300 330 und ETSI EN 301 489: Class 2

When properly used this radio equipment conforms

to the essential requirements of Article 3 and the

other relevant provisions of the R&TTE Directive

1999/5/EC of March 99.

Equipment Classification according to

ETSI EN 300 330 and ETSI EN 301 489: Class 2

FCC ID PJMCPR4030

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) this device may not cause harmful interference, and

(2) this device must accept any interference received, including interference that may cause undesired op-

eration.

Any changes or modifications not expressly approved by the party responsible for compliance could void the

user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against

harmful interference in a residential installation. This equipment generates, uses and can radiate radio fre-

quency energy and, if not installed and used in accordance with the instructions, may cause harmful inter-

ference to radio communications. However, there is no guarantee that interference will not occur in a par-

ticular installation. If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

Liefermöglichkeiten und technische Änderungen

vorbehalten.

FEIG ELECTRONIC GmbH übernimmt keine Gewährleis-

tung dafür, dass die in diesem Dokument enthaltenden In-

formationen frei von fremden Schutzrechten sind. FEIG

ELECTRONIC GmbH erteilt mit diesem Dokument keine

Lizenzen auf eigene oder fremde Patente oder andere

Schutzrechte. ID CPR4030-Manual-L 02062008.doc

Data and design subject to change without notice. Supply

subject to availability.

FEIG ELECTRONIC GmbH assumes no responsibility for

the use of any information contained in this manual and

makes no representation that they free of patent infringe-

ment. FEIG ELECTRONIC GmbH does not convey any li-

cense under its patent rights nor the rights of others.

OBID

and OBID i-scan

are registered trademarks of FEIG ELECTRONIC GmbH.

All cited brand names, product names, or trademarks belong to their respective holders.