User's Manual

OBID
®
classic-pro Installation ID CPR.03-VP/AB-A
FEIG ELECTRONIC GmbH
Page 4 of 11
1 Safety Instructions / Warning - Read before start-up !
• The device may only be used for the intended purpose designed by for the
manufacturer.
• The operation manual should be conveniently kept available at all times for each user.
• Unauthorized changes and the use of spare parts and additional devices which have not
been sold or recommended by the manufacturer may cause fire, electric shocks or
injuries. Such unauthorized measures shall exclude any liability by the manufacturer.
• The liability-prescriptions of the manufacturer in the issue valid at the time of purchase
are valid for the device. The manufacturer shall not be held legally responsible for
inaccuracies, errors, or omissions in the manual or automatically set parameters for a
device or for an incorrect application of a device.
• Repairs may only be executed by the manufacturer.
• Installation, operation, and maintenance procedures should only be carried out by
qualified personnel.
• Use of the device and its installation must be in accordance with national legal
requirements and local electrical codes .
• When working on devices the valid safety regulations must be observed.
• Special advice for carriers of cardiac pacemakers:
Although this device doesn't exceed the valid limits for electromagnetic fields you
should keep a minimum distance of 25 cm between the device and your cardiac pace-
maker and not stay in an immediate proximity of the device respective the antenna for
some time.
2 Introduction
The Multitag-Reader ID CPR.03-VP/AB-A is designed for access control and time-recording sys-
tems. Via the configurable data-/clock interface it can connected easily with usual access control
and time-recording controllers.
The ID CPR.03-VP/AB-A could read the serial-no. (UID) of the most common 13,56 MHz Trans-
ponder according ISO 14443 type A, ISO 14443 type B and ISO 15693.
The ID CPR.03-VP/AB-A is designed to be wall-mounted onto flat and non-conductive walls with or
without a flush-mounting box.
The data-/clock interface could configured like Wiegand- or magnetic stripe format (ISO7811-2,
5 Bit).
The configuration could changed while installation with a ConfigCard transponder. This ConfigCard
could prepared comfortable before Installation with a separate tool.