User's Manual

OBID
®
classic pro
Installation ID CPR.02-x
Page 24 of 36 FEIG ELECTRONIC GmbH
2.1 Installation on flush-mounting box
1. Select installation place:
The installation should be executed always on a surface as even as possible.
2. Connection:
see chapter Reader-connection
3. Operation:
• snap connection board into bottom part of casing (see Fig 2).
• Put the top of the casing onto its bottom part. The pin board of the Reader electronic has to
be inserted carefully into the socket board X3!
• see chapter Installation
4. Wall installation:
The wall installation should be executed only after a control of all functions.
• Remove top of the casing from its bottom part.
• Screw bottom part of casing with snapped-in connection board to selected surface.
• Put top of the casing again onto its bottom part. Insert the pin board of the Reader electronic
carefully in the socket board X3!
• Screw top of casing to bottom part by using thread cutting screw 3,2 x 25 mm.
• Attach adhesive label to clean and non-greasy casing.
(1)
X3
Fig 2: Rear view with snapped-in connection board (1)