Installation Manual

OBID i-scan

Installation ID ISC.ANT1300/680-A

FEIG ELECTRONIC GmbH Page 9 of 50 M71104-1e-ID-B.doc

3.2 Mounting preparation

For assembly the antenna must be carefully unpacked. This is done as described in the following

steps:

1. Place the packed antenna on the floor with the top side facing up. Carefully open the box and

then remove the antenna.

Fig. 2: Antenna in its packaging

2. After that the antenna has to be placed carefully again on the floor. Now you must remove the

to fastening screws (hexagon socket width A/F2,5) of the antenna foot cover and remove it

upwards. Fig. 3

Step 1 Step 2

Fig. 3: Opening the antenna foot