Installation Manual

OBID i-scan
®
Installation ID ISC.ANT1300/680-A
FEIG ELECTRONIC GmbH Page 33 of 50 M71104-1e-ID-B.doc
Step Action Note
6
CFG1: Interface and Mode
To tune, activate “ISO-Host
Mode”
7
Set by clicking on “Write”
8
CFG15:
Antenna Multiplexing Ι
Activate „Multiplexing“
Configure the parameters as
follows:
• „Switching Condition“ –
after no response
• „Number of Input
Channels“ – 1 Input
(Single Mode)
• „MUX-Valid Time“ – 100 x
5 ms
• „Number of Output
Channels“ => 2
9
Set by clicking on “Write”