Installation Manual

OBID i-scan
®
Installation ID ISC.ANT1300/680-A
FEIG ELECTRONIC GmbH Page 29 of 50 M71104-1e-ID-B.doc
4.3.4 Setting the Multiplexer
Set the jumpers JP1-JP8, JP11-JP18 and DIP switch S1 on the Multiplexer as shown. More on
setting the ID ISC.ANT.MUX Multiplexer can be found in the corresponding installation manual
(M30201-xde-ID-B).
Fig. 14: DIP-Switch and Jumper positions
4.3.5 DIP Switch Configuration
The DIP switch should be configured as indicated in the following table:
Table 5: DIP switch configuration
DIP-switch S1
1 2 3 4 5 6 7 8
ONOFFOFFON----