Installation Manual

OBID i-scan
®
Installation ID ISC.ANT1300/680-A
FEIG ELECTRONIC GmbH Page 27 of 50 M71104-1e-ID-B.doc
5
Mounting of the DC-
cables Pos.2 of the
readers and of the
Multiplexer with 2
pieces of cable tie
2,5x105mm Pos.6
Attention! Take care
of polarity.
6
Connect DC- cables
to Terminal block
Red wire to terminal
1+2 (+24V), Black
wire to terminal 3+4
(GND)
. Attention! Take care of polarity.
7
Connect the antenna
cable with Out 1 of
Multiplexer. Wind up
the rest of the cable
to loops and tied it
together with 2
pieces of cable tie
4,8x280mm Pos.5
8
Mounting of the co-
axial cable between
X1 Reader and IN1
Multiplexer. Connect
the 1,35m and the
3,65m cable using
the SMA Adapter
Pos.7. Mount the
torrid from the reader
attachment approx.
10cm with 4 turns
before the reader.
9
Wind up the rest of
the cable to loops
and tied it together
with 2 pieces of cable
tie 4,8x280mm Pos.5
and place it in the
antenna foot.
X
1
OUT1
IN1