Installation Manual

OBID i-scan
®
Installation ID ISC.ANT1300/680-A
FEIG ELECTRONIC GmbH Page 22 of 50 M71104-1e-ID-B.doc
4.2.7 Reader Configuration with Power Splitter
To tune the antennas, open the ISOStart software and first read out the current configuration of the
Reader:
Step Action Note
1
Start ISOStart Software
2
Run „Detect“...
3
...follow „New-File
Assistant“...
4
...and read out the current
Reader Configuration
Then set the operating power, Transponder Parameters and ISO Host Mode:
Step Action Note
1
Select “Configuration”
2
CFG3: RF-Interface:
“RF-POWER” (here 8W)
Select “Transponders-Drivers”
(here ISO 15693)
3
Set by clicking on “Write”
4
CFG4:
Transponder Parameters
Configure the parameters as
follows (ISO15693 Mode):
• „Datacoding“ – 1 of 4
• „MOD“ – 10%
• „SUB-CARRIER“ – ASK
• „DATA-RATE“ – High
• „NO-TS“ – 16 Timeslots
• „AFI“ – Disabled
Note: National RF regulations may require different
settings. (see 4.7 Configuring the Reader in accordance
with national RF regulations)
5
Set by clicking on “Write”