Installation Manual

OBID i-scan

Installation ID ISC.ANT1300/680-A

FEIG ELECTRONIC GmbH Page 21 of 50 M71104-1e-ID-B.doc

Now you must remove the to fastening screws (hexagon socket width A/F2,5) of the antenna tuner

cover and remove it upwards. Fig. 11

Step 3 Step 4

Fig. 11 Removing the antenna tuner cover

The ID ISC.ANT1300/680-A antennas are factory set as follows:

Table 4: Jumper settings for Antenna Tuner

Function Jumper Position

1Ω Q resistor

JP1 open

2Ω Q resistor

JP2 closed

Antenna switch JP3 closed

Capacitor C1 JP 11,12,13,14 open

Capacitor C2 JP 21,22,25,26

JP 23,24

open

closed

Verify these settings. More on setting the ID ISC.DAT antenna tuner can be found in the

corresponding installation manual (M40401-xde-ID-B).