Installation Manual

OBID i-scan
®
Installation ID ISC.ANT1300/680-A
FEIG ELECTRONIC GmbH Page 20 of 50 M71104-1e-ID-B.doc
4.2.5 Setting the Power Splitter
Set the jumpers on the Power Splitter as shown Table 3:Power Splitter setting. More information
about setting the ID ISC.ANT.PS-BM Power Splitter can be found in the corresponding installation
manual (M40402-xde-ID-B).
Table 3:Power Splitter setting
Trans-
former
Power
Splitter
Phase
shifter
JP1 JP3 JP4 JP5 JP6
not used X X
3-5
4-6
2-4 1-2 1-2
1-2
3-4
Power Splitter with 90° phase shifter
X1: Reader
X2: Antenna
X3: Antenna
X4: 12-24V DC for Antenna with dyn.
antenna tuner ID ISC.DAT
4.2.6 Setting the Antenna Tuner
To check the settings of the antenna tuner the antenna foot has to be opened. For that you must
remove the to fastening screws (hexagon socket width A/F2,5) of the antenna foot cover and
remove it upwards. Fig. 10
Step 1 Step 2
Fig. 10: Opening of the antenna foot