Installation Manual

OBID i-scan
®
Installation ID ISC.ANT1300/680-A
FEIG ELECTRONIC GmbH Page 15 of 50 M71104-1e-ID-B.doc
4.2 Configuration and Setup using Antenna Type -A with power splitter
4.2.1 Required Components
To construct the gate you need the following components:
- Qty. 2 Antenna ID ISC.ANT1300/6800 Type A
- Qty. 1 Reader module ID ISC.LR2000-A-M
- Qty. 1 Power splitter module ID ISC.ANT-PS-BM
- Qty. 1 Gate integration kit ID ISC.ANT.GIK
- Qty. 1 power supply ID ISC.NET24-B
- Power cable, interface cable and connection cable for the DC power supplies (2-wire,
twisted)
- Mounting materials (screws, anchors)
Optional:
- Qty. 1 Alarm Kit ID ISC.ANT.GAK
To configure the Reader you will need the software
- ISOStart Version 7.01 or higher
and for tuning the antennas the service software
- DATuningTool Version 1.00 or higher
on a personal computer running under Microsoft
®
Windows
®
. The service software is included on
the OBID
i-scan
®
CD obtained from FEIG ELECTRONIC GmbH or can be downloaded on the
Download Area of the Homepage www.feig.de.