User's Manual

ASSEMBLY INSTRUCTIONS
Wheel Assembly
Tools required for assembly: Phillips head screwdriver
Carefully unpack your Bionaire
®
heater from the box (it is
recommended to save the box for off-season storage).
You will find the following pieces:
1. Four casters (wheels) 2. Four screws 3. Two caster (wheel platforms)
WARNING DO NOT ATTEMPT TO OPERATE THE
HEATER WITHOUT THE WHEELS IN PLACE
1. Make sure the unit is unplugged. Using a slotted or Phillips
head screwdriver, attach two casters to each caster
platform.
2. Carefully turn the unit over
so the caster platforms can
be attached.
3. Slide the caster platform
into the bottom of the plas-
tic end cap, following the
grooves (shown in Fig. 1).
4. Repeat this sequence on the other side of the heater, making
sure both sides are secure.
5. Return the console to its upright position.
FIRST USE ONLY:
1. Put batteries into Remote. The "Room" temperature is
displayed at all times. (Use 3 AAA Alkaline batteries
only, do not mix batteries)
2. Plug unit into outlet. The first time the unit is plugged
in, it will beep every two seconds until it is synced with
the remote. To sync unit with remote follow the below
steps:
Unlock remote. (This must be done before each use of
the remote) To Unlock remote, hold down the mode
button for 2 seconds until the lock symbol disappears
on the screen. Once the remote is unlocked, press the
mode button again and the unit will quickly beep 5
times telling the user the signal was received. DO NOT
SYNC more than 1 unit at once. A hazardous situation
may occur.
Note: If the batteries are running low on power, a low
battery indicator will appear on the remote. Low batteries
will affect transmission distance and the screen contrast.
We recommend replacing batteries immediately.
Note: The transmission distance for this remote is 30 ft,
do not use outside of 30 ft area of appliance. Remote
must be used in same room as appliance.
Note: Galileo can be used in either Fahrenheit or Celsius.
To change the reading on the remote, flip the remote over
and push the button located on the left hand side with a
ball point pen tip. This switch will change the reading from
F to C and vice versa.
Note: Every minute while in Auto mode, the Galileo com-
munications with the base unit. If the Galileo goes out of
range and/or has low batteries, the communication will
stop, and after 8 minutes of non-communication the unit
wil shut off.
MANUAL OPERATION WITH REMOTE
1. Press Mode button on the remote. "Low" illuminates
on remote screen indicating mode. The power light
on the unit will turn on. The unit turns on and
operates in "Low" mode. The units "Low" light will
illuminate. In this mode, the unit will continuously run at
its low wattage.
4
Fig. 1
Caster
Platform
Casters
(Wheels)
X 4
mode
Figure 2
low
high
mode
auto
LOW
(1000 Watts)
HIGH
(1500 Watts)
AUTO
MODE
Figure 3
5