User's Manual

ManualsBrandsFego Precision Industrial ManualsCooling & Air QualityQuieTech Dehumidifier

Table Of Contents

BDQ25 unit function

Fego Co .,Ltd :Beennan Date:2004/11/3

! POWER

AC︰120V/60HZ

! RF and receiver function description:

Unit will send RF signal to receiver tell it unit status for user can know the unit status .

This RF signal will send every 15 second.

KEYBOARD FUNDTION

● MODE/POWER button operate description:

★ Dehumidifiers have five five operating mode︰Economy，Continuous，45%-

55% humidity-setting，55%-65% humidity- setting、Off mode。

★ Fan speed can’t be adjusted，it operate just only at any mode except Off and

tank full situation.

★ Pressing MODE/POWER button mode will action after release button one

second but choose Off mode it will action after after release button three

second.

★ When press and hold MODE/POWER button over 3 second system will enter

off mode.

If customer press button again it will come to Economy mode.

★ When pressing the MODE/POWER button first time，choose Economy mode

and the economy led will on and monitor display the room humidity.

★ When pressing the MODE/POWER button second time，choose Continuous

and the Continuous led will on and monitor display the room humidity.

★ When pressing the MODE/POWER key third time，choose 45%-55%

humidity-setting，and the “45%-55%” led will on and monitor display the room

humidity.

★ When pressing the MODE/POWER key fourth time，choose 55%-65%

humidity-setting，and the “55%-65%” led will on and monitor display the room

humidity.

★ When pressing the MODE/POWER key fifth time, back to off mode,

Mode/Power button led will on and monitor display the room humidity.

● Mode Description:

★ First power plug in : compressor and fan stop , Mode/Power button led will on

and monitor display the room humidity. System will check tank full or not. If

full ,tank led will flash and have three times beep. At the same time system will

check Humidity sensor and temperature sensor and tank full switch install

Summary of content (6 pages)

PAGE 1
BDQ25 unit function Fego Co .,Ltd :Beennan ! Date:2004/11/3 POWER AC︰120V/60HZ ! RF and receiver function description: Unit will send RF signal to receiver tell it unit status for user can know the unit status . This RF signal will send every 15 second.
PAGE 2
correct not. ★ Economy mode : economy led will on . if room humidity over or equal 65% fan and compressor on(if compressor stop before, it is on at the three minutes safe time, if safe time is not arrive, it wont run. Over the safe time,than it will run) start dehumidity . When the room humidity lower 65%, compressor stop but fan still running when room humidity continue lower 70% within one minute fan will off. But Holmes hope fan stop after running 3 minute. Norm will check BDQ24 function.
PAGE 3
● ● OFF mode Entering this mode, turn off the compressor and fan . Tank full Dspite any mode, stop the compressor right now when tank is full. If tank still full with in one minute then off fan otherwise fan will still running and system will inform receiver per 10second. When tank in full tank full led will flash and beep three times and then beep per second. Display show room humidity. When tank water empty then tank full led will off and keep last mode running.
PAGE 4
● running protection time compressor will not runnig it need pass three miniute then can start at any mode. ★ Compressor need three minutes to stop running before last running.Its function is prevent compressor overload. Defrost: ★ Defrost condition: when evaporator temperature lower or equal -1.5。C continue over 20minutes it will start deforest action. But when evaporator temperature over 0。C, system will stop counting time.
PAGE 5
★ Pressing POWER/MODE key again, turn off the compressor , fan and display, only OFF pilotlamp flashing, means that the test is over, POWER/MODE key doesnot work. ★ In testing, if tank is full, Tank full pilotlamp flashing, and beeps three times. What display brings out originally, and the condition of the fan and compressor will not change. If tank didn’t full ,tank full symbol will not show.
PAGE 6