User's Manual

activate yarn retraction.
¾ When wind speed continues to be greater than set value for 3 minutes continuously, send
command to activate yarn retraction.
¾ When fan speed is greater than set speed for 2 seconds consecutively, send signal for yarn
retraction, after retraction, if wind speed is lower than set value then speed up to be greater
than set speed, send over set speed command to retract yarn..
¾ When wind speed is lower than set value for 8 minutes consecutively, send “wind lower
than set speed command
¾ After “wind lower than set speed command” is sent, yarn will not extract unless lux
greater than set value has continued for 8 minutes. If true, send command to extract yarn.
 OFF Mode:
¾ Turn off wind speed function.
7、Lux Mode
 Demo MODE:
¾ When lux is greater than set value for 2 seconds consecutively, send command to extract
yarn.
¾ When lux is lower than set value for 2 seconds consecutively, send command to retract
yarn.
¾ DEMO mode, any minor signal is determined to be over set value.
 On Mode:
¾ When lux is greater than set value for 8 minutes consecutively, send command to activate
yarn extraction.
¾ When lux is lower than set value for 8 minutes consecutively, send command to retract
yarn.
 OFF Mode:
¾ Same as On jmode。
8、Status and activation time
Status Normal DEMO OFF
Lux over set value 8MIN 2 SEC 8MIN
Lux below set value 8MIN 2 SEC 8MIN
Wind speed over set value 2SEC 2 SEC
Wind speed below set value 8MIN 2 SEC