Manual
Chapter 4: System Setup and Wiring
4.10.2 Controller Unit DIP Switch positions 4 ~ 8
DIP switch positions 4 ~ 8 are used for setting the
described in the following table.
from multiple spindles whereas the data needs to be identified differently between each spi
dle.
Do not set two spindles with the same address.
Note: The Controller
unit must be powered off a
to be initialized
Unit
No.
DIP SWITCH NUMBER
4 5 6 7
1 OFF
OFF
OFF
OFF
2 OFF
OFF
OFF
ON
3 OFF
OFF
OFF
ON
4 OFF
OFF
ON
OFF
5 OFF
OFF
ON
OFF
6 OFF
OFF
ON
ON
7 OFF
OFF
ON
ON
8 OFF
ON OFF
OFF
9 OFF
ON OFF
OFF
10 OFF
ON OFF
ON
11 OFF
ON OFF
ON
12 OFF
ON ON
OFF
13 OFF
ON ON
OFF
14 OFF
ON ON
ON
15 OFF
ON ON
ON
Page 4-28
4.10.2 Controller Unit DIP Switch positions 4 ~ 8
DIP switch positions 4 ~ 8 are used for setting the
Controller
unit spindle address number as
described in the following table.
This can be beneficial if fastening data is being collected
from multiple spindles whereas the data needs to be identified differently between each spi
Do not set two spindles with the same address.
unit must be powered off a
nd on again for the DIP switch changes
DIP SWITCH NUMBER
Unit
No.
DIP SWITCH NUMBER
8 4 5 6 7
8
OFF
ON 16 ON OFF
OFF
OFF
OFF
ON
OFF 17 ON OFF
OFF
OFF
ON
ON
ON 18 ON OFF
OFF
ON
OFF
OFF
OFF 19 ON OFF
OFF
ON
ON
OFF
ON 20 ON OFF
ON OFF
OFF
ON
OFF 21 ON OFF
ON OFF
ON
ON
ON 22 ON OFF
ON ON
OFF
OFF
OFF 23 ON OFF
ON ON
ON
OFF
ON 24 ON ON OFF
OFF
OFF
ON
OFF 25 ON ON OFF
OFF
ON
ON
ON 26 ON ON OFF
ON
OFF
OFF
OFF 27 ON ON OFF
ON
ON
OFF
ON 28 ON ON ON OFF
OFF
ON
OFF 29 ON ON ON OFF
ON
ON
ON 30 ON ON ON ON
OFF
31 ON ON ON ON
ON
unit spindle address number as
This can be beneficial if fastening data is being collected
from multiple spindles whereas the data needs to be identified differently between each spi
n-
nd on again for the DIP switch changes
8
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON
OFF
ON