Manual

FEC FUSION Operations Manual
4.10 Controller
Unit DIP Switch
In a multiple
controller u
zational
purposes. The number is set using the DIP switch located
on the back panel
of the unit.
DIP switch located on printed
c
ircuit board through access
p
anel at the back of unit.
4.10.1 Controller
Unit DIP Switch positions 1 ~ 3
•
DIP switch positions 1 ~ 3 are used for setting the special configuration features as defined in the
following explanation
. The DEFAULT setting is switch 1
• DIP Switch 1 - Zero
Check
o ON – Expanded
Zero
o OFF – Normal
Zero
• DIP Switch 2 -
NOT USED
o ON – Not Used
o OFF – Not Used
• DIP Switch 3 -
Disable Motor Ramp Down
o ON -
Enables dynamic brake for motor speed changes.
-
Used for applications which overshoot standard torque
-
Will reduce Motor/Tool life
o OFF -
Disables Dynamic brake during speed changes (Default)
Note: The Controller
unit must be powered off and on
initialized.
FEC FUSION Operations Manual
Chapter 4: System Setup and Wiring (Rev. 2.1)
Page 4-27
Unit DIP Switch
Setting.
controller u
nit system, it may be beneficial to address the
controllers
purposes. The number is set using the DIP switch located
behind the access panel
of the unit.
DIP switch located on printed
ircuit board through access
anel at the back of unit.
FIG. 4-10 Dip Switch settings
Unit DIP Switch positions 1 ~ 3
DIP switch positions 1 ~ 3 are used for setting the special configuration features as defined in the
. The DEFAULT setting is switch 1
– 3 OFF.
Check
acceptance window selection.
Zero
Check acceptance window
Zero
Check acceptance window
NOT USED
Disable Motor Ramp Down
.
Enables dynamic brake for motor speed changes.
Used for applications which overshoot standard torque
Will reduce Motor/Tool life
Disables Dynamic brake during speed changes (Default)
unit must be powered off and on
again for the DIP switch changes to be
Chapter 4: System Setup and Wiring (Rev. 2.1)
controllers
for organi-
behind the access panel
DIP switch positions 1 ~ 3 are used for setting the special configuration features as defined in the
again for the DIP switch changes to be