Manual

FEC FUSION Operations Manual Chapter 4: System Setup and Wiring (Rev. 2.1)
Page 4-25
4.8.5 Rear Panel RS232 Alternate Communication Protocol
An alternate communication protocol is available upon set-up in a different “Fastening Func-
tion Mode” (See 7.2.5 Fastening Function Version [Work]-00, [D-No]-03) If the system is set-
up in a “DDK” mode, this protocol becomes the Standard Communication Protocol.
This alternate protocol has 79 bytes of data per fastening.
Byte
1 2 3 4 5 6 7 8 9 10 11 12 13 14
Desc.
Cycle Count
Spindle
Number
Work
Number
ASCII
Hex
30H 30H 30H 31H 20H 20H 30H 31H 20H 20H 20H 31H 20H 20H
Data
0 0 0 1 0 1 1
Byte
15 16 17 18 19 20 21 22 23 24 25 26 27 28
Desc.
Peak Torque Judge Final Angle Judge
ASCII
Hex
31H 32H 2EH 33H 34H 4CH 20H 20H 20H 20H 35H 30H 48H 20H
Data
1 2 . 3 4 L 5 0 H
Byte
29 30 31 32 33 34 35 36 37 38 39 40 41 42 43 44
Desc.
Final Torque Judge 1st Rate Judge
ASCII
Hex
31H 32H 2EH 33H 34H 20H 20H 20H 30H 2EH 31H 32H 33H 20H 20H 20H
Data
1 2 . 3 4 0 . 1 2 3
Byte
45 46 47 48 49 50 51 52 53 54 55 56 57 58 59 60
Desc.
2nd Rate Judge 3rd Rate Judge
ASCII
Hex
30H 2EH 31H 32H 33H 20H 20H 20H 30H 2EH 31H 32H 33H 20H 20H 20H
Data
0 . 1 2 3 0 . 1 2 3
Byte
61 62 63 64 65 66 67 68 69 70 71 72 73 74 75 76 77 78 79
Desc.
1st Time Judge 2nd Time Judge
Final
Judge
CR LF
ASCII
Hex
20H 31H 30H 2EH 30H 20H 20H 20H 20H 20H 32H 2EH 30H 20H 20H 20H 58H 0DH 0AH
Data
1 0 . 0 2 . 0 X
Final Judgment: “X” Reject = 58H, “O” Accept = 4FH, “A” Abnormal = 41H, “S” Stop=53H, “B” Bypass=42H
Judge: “H” High Reject= 48H, “L” Low Reject= 4CH (H = Hex)