Manual

FEC FUSION Operations Manual
4.4.3 Pistol Tools
The FEC Pistol tool is available in two configurati
tol style. The “T” style is for applications where the tool will be hung using some type of
overhead hanging device and where the tool will be exposed to torques larger than 12 Nm
without a torque reaction device
erator and used for torques smaller than 1
Note
: It is recommended when
other torque reaction devices
duce operator fatigue or injury.
The FEC Pistol tool incorporates the latest “active
duce operator torque reaction to very low levels.
function to apply torque to the fastener. This is extremely effective in applications where the
tool is supported from some type of cable of other balancer.
for set-up of Ergo-
Smo
Tools
may be used in horizontal or vertical applications
“T” Type
Pistol
HFT-TYPE TORQUE SPEED A
040M80-T 4.0KgM 694 250
* Up to 15Nm –
over 15Nm, weight increases 0.5kg
FEC FUSION Operations Manual
Chapter 4: System Setup and Wiring (Rev. 2.1)
Page 4-7
The FEC Pistol tool is available in two configurati
ons. The “T” style and the standard “P” pi
tol style. The “T” style is for applications where the tool will be hung using some type of
overhead hanging device and where the tool will be exposed to torques larger than 12 Nm
without a torque reaction device
.
The “P” type is for applications that will be held by the o
erator and used for torques smaller than 1
5Nm.
: It is recommended when
using pistol type tools, that the “Ergo-
Smoothing” function
other torque reaction devices
are used on applicati
ons with target torques over 12Nm to r
duce operator fatigue or injury.
The FEC Pistol tool incorporates the latest “active
Ergonomic smoothing” technology to r
duce operator torque reaction to very low levels.
This works by using an electric “pulsing”
function to apply torque to the fastener. This is extremely effective in applications where the
tool is supported from some type of cable of other balancer.
(See Parameter data list (7.2.5)
Smo
othing function – Data No. 80 - 89)
may be used in horizontal or vertical applications
using supplied hanging bracket
Pistol
Tool
Fig. 4.4.3a “T” Type Pistol Tool
B C D E F G H K
418 182 60 182 23 20 111 44
over 15Nm, weight increases 0.5kg
Chapter 4: System Setup and Wiring (Rev. 2.1)
ons. The “T” style and the standard “P” pi
s-
tol style. The “T” style is for applications where the tool will be hung using some type of
overhead hanging device and where the tool will be exposed to torques larger than 12 Nm
The “P” type is for applications that will be held by the o
p-
Smoothing” function
or
ons with target torques over 12Nm to r
e-
Ergonomic smoothing” technology to r
e-
This works by using an electric “pulsing”
function to apply torque to the fastener. This is extremely effective in applications where the
(See Parameter data list (7.2.5)
using supplied hanging bracket
.
L M N WEIGHT
9.5 (.375) 310 12 1.6* Kg