Manual

Chapter 4: System Setup and Wiring
4.4.2 Right Angle Tool
FIG. 4-
4
HFT-TYPE TORQUE SPEED A
015M50-A1 1.5KgM 1215 rpm 381
025M80-A 2.5KgM 1218 rpm 401
040M80-A1 4.0KgM 648 rpm 426
060M80-A 6.0KgM 446 rpm 426
080M80-A 8.0KgM 330rpm 507
130M80-A 13.0KgM 203 rpm 516
Mounting: Tool
may be mounted by using a clamp collar located in the area shown in the
d
rawing above. Tolerance for diameter of inside of clamp
of dimension shown in dimension “S”.
Warning:
Diameter of clamping device
diameter of clamp area or tool damage may result.
Note: Dimensions shown are subject to change without warning due to design improvements.
HFT-TYPE M N P Q
015M50-A1 11 25 38 11
025M80-A 11 25 38 11
040M80-A1 11 25 40 13
060M80-A 18 25 45 13
080M80-A 18 37 73.5 14.5
130M80-A 18 37 73.5 14.5
Page 4-6
4
-2 Right Angle Tool (dimensions in mm)
B C D E F H J K
72 62 247 14 20 16 14 28
72 62 267 14 20 16 14 28
90 69 267 14 20 16 18 36
90 69 267 14 20 16 18 36
125 119 263 18 27 16 22.5 45
125 128 263 18 27 16 22.5 45
may be mounted by using a clamp collar located in the area shown in the
rawing above. Tolerance for diameter of inside of clamp
must be
+0.1 to +0.2
of dimension shown in dimension “S”.
Diameter of clamping device
must not be smaller than the specified “R
”
diameter of clamp area or tool damage may result.
Note: Dimensions shown are subject to change without warning due to design improvements.
R T V W X Y Z
WEIGHT
38 46 50 36 55 43 76
38 46 50 36 55 43 76
40 46 50 36 55 43 76
40 46 50 36 55 43 76
54 58.5 50 36 55 43 76
54 58.5 50 36 55 43 76
L
9.5 (.374)
9.5 (.374)
9.5 (.374)
12.7 (.50)
12.7 (.50)
12.7 (.50)
may be mounted by using a clamp collar located in the area shown in the
+0.1 to +0.2
”
or “T”
Note: Dimensions shown are subject to change without warning due to design improvements.
WEIGHT
1.3 Kg
1.7 Kg
1.9 Kg
1.9 Kg
3.8 Kg
3.8 Kg