Manual

Chapter 2: Specifications
Page 2-6
2.4.1 Nutrunner Tool Specification Table.
TOOL TYPE
SERVO
TYPE
CALIBRATION TORQUE
SPEED
RPM
Weight
Sq.
Drive
Length
NM KGM KGCM FTLB INLB MAX MIN (Kg) (inch) (mm)
ANGLE
HFT-015M50-A1 HFC-EC-16 14.7 1.5 150 10.8 130.2 1215 1 1.3 3/8 381
HFT-025M80-A1 HFC-EC-16 24.5 2.5 250 18.1 217.0 1070 1 1.7 3/8 400
HFT-040M80-A1 HFC-EC-16 39.2 4.0 400 28.9 347.2 648 1 1.9 3/8 425
HFT-060M80-A HFC-EC-16 58.8 6.0 600 43.4 520.8 446 1 1.9 1/2 425
HFT-080M80-A HFC-EC-16 78.4 8.0 800 57.9 694.4 330 1 3.8 1/2 507
HFT-130M80-A HFC-EC-16 127.5 13.0 1300 94.0 1128.4 203 1 3.8 1/2 516
STRAIGHT
HFT-010M50-S1 HFC-EC-16 9.8 1.0 100 7.2 86.8 1665 1 1.3 3/8 342
HFT-015M80-S1 HFC-EC-16 14.7 1.5 150 10.8 130.2 1665 1 1.4 3/8 363
HFT-025M80-S1 HFC-EC-16 24.5 2.5 250 18.1 217.0 900 1 1.4 3/8 363
HFT-040M80-S HFC-EC-16 39.2 4.0 400 28.9 347.2 694 1 1.4 3/8 363
HFT-080M80-S HFC-EC-16 TBA
PISTOL
HFT-015M50-P HFC-EC-16 14.7 1.5 150 10.8 130.2 1000 1 1.4 3/8 230
HFT-040M80-P HFC-EC-16 39.2 4.0 400 28.9 346.9 694 1 1.8 3/8 230
HFT-040M80-T HFC-EC-16 39.2 4.0 400 28.9 346.9 694 1 1.8 3/8 250
CONVERSION GUIDE: 1 KGM = 100 KGCM = 9.8 NM = 7.2 FTLB = 86.8 INLB
FULL SCALE TORQUE VALUES (WORK 1~16 D-NO 10) IN CONTROLLER ARE BASED
UPON LIMIT SET BY Kgm VALUE.
The tool lists located throughout this manual identify the specifications for the stan-
dard tools used with the FUSION System. Additional tools are available. If additional
capacity, information or special needs are required, please contact FEC INC.